ARES
Home Page

ARES
800-421-1266

 
 

Quote Request Form

Please use this form to request a Quote from ARES

Name:
Title:
Company:
Address:
City:
State:
Zip:
Phone:
Fax:
EMail:

Which of the Following Best Describes Your Business:

Manufacturer . . . . Manufacturer's Representative . . . . Wholesaler / Distributor
Contractor . . . . . .. Building Owner / End User

Briefly Describe This Make-Up Air Application:

Pick from the Following Types of Heating and Cooling Options required

Indirect Fired
. . . . . . 2 Stage Gas Valve
. . . . . . Electronic Modulating Gas Valve

Blower Only

Standard Evaporative Cooling
* Hydronic Chilled Water Coil

Direct Fired Gas
* Hydronic Steam Coil
* Hydronic Hot Water Coil

Electric Resistance Heat

High Efficiency Evaporative Cooling
* Mechanical Cooling Direct Expansion Coil

*For all coil applications any or all of the following information is required to size the
appropriate coil selection.

E.A.T. . . D.B.
. .. . . . . . ..W.B.

L.A.T. .....D.B.
. . . . . . . . .W.B.

B.T.U. . . . . .. .E.W.T.
------------------.-G.P.M.
--------------------L.W.T.

The Following Information is Necessary for All Make-Up Air Applications

C.F.M. ------ E.S.P.
Temperature Rise or B.T.U.
H.P. ------ Voltage ------
Phase


Choose from any of the Following Options You Require:

Full Perimeter Roof Curb ------ Down Discharge Plenum
Rainhood ------ Exhaust Fan Interlock / Starter Control Panel
Exhaust Fan Interlock relay Only

Dampers:

Motorized Inlet Air Damper
Back Draft Damper
------ Motorized
------ Blast-Open

Return Air Section O/A & R/A Dampers
----- 2 Position Spring Return Motor (Standard)
----- Modulating Spring Return Motor

Evaporative Cooling:

12" Celdek------------- 12" Glasdek------------- 2" Glacier-Cor

Cabinet Finish:
G-90 Galvanized ------ 304 Stainless Steel

Miscellaneous Options:

Flat Bank Filter Section (Typically used on indoor units only)
Exterior Paint (Polyurethane Air Dry Enamel)
Room Override Thermostat (Heat Only)
Fill & Drain Kit (Necessary only on standard Evap. Unit)
Fused Disconnect

All Quotations will be based on these general perameters. If your quotation requires more specific information, it is the responsibility of the person requesting the quotation to forward this information for consideration.

If Engineering Specifications are available for your project, it is recommended that you forward this information to ARES for evaluation.

If You have Any Questions,
Please call ARES Toll Free at:
800-421-1266


ARES
14716 South Broadway
Gardena, California 90248
800-421-1266

Phone: 310-532-1555 | FAX: 310-324-3030
EMail: aresinfo@marsair.com

 

© 2000 MARS AIR PRODUCTS all rights reserved
LTG&A, Inc.